Carrel Electrade - LP-IP, LP-IL Transducer


Home	Contact

Electrical Transducers

Data sheet

LP-IP Separately Powered &
LP-IL Loop Powered Current Transducers

The LP-IP and LP-IL current transducers convert an ac current input into an output signal which is proportional to the rectified arithmetic mean of the input.
Accurate measurement assumes a sinusoidal input waveform.
Power for the units is derived from an external supply.

Ordering information: LP-IP, input, output, power supply. LP-IL, input.
Examples: LP-IP, input 0-1A, output 0-10mA, supply 110Vdc. LP-IL, input 0-5A.

Basic Specifications:
Input	Ranges	: 1A, 5A (others on request)
	Burden	: <0.1VA
	Overload	: 2xI_nom continuous, 20xI_nom for 3 seconds
	Frequency	: 50Hz, 60Hz
Outputs	LP-IP load independent dc current or voltage
		: 0 - 10mA dc <1500Ω load
		: 0 - 20mA dc <750Ω load
		: 4 - 20mA dc <750Ω load
		: 0 - 5V dc >2kΩ load
		: 0 - 10V dc >2kΩ load
Output	LP-IL load independent dc current
		: 4 - 20mA dc <750Ω load
Accuracy		: Class 0.5 to IEC 60688
	Range	: 0 to 120% of nominal input
Power Supply	LP-IP	: 24V, 110V, 230/240V ac ±20%, 1.5VA
		: 24V dc ±20% or 110V/125V dc (88V-138V), 2W
Loop Supply	LP-IL	: 10 - 30V dc
Isolation	LP-IP, galvanic isolation between input, output circuit and auxiliary supply
	LP-IL galvanic isolation between input & output circuit
	Test voltage	: 4kV 50Hz ac for 1 minute
Temperature	Operating	: 0°C to +23°C to +60°C
EMC Compliance		: AS/NZS 61000.6.3:2012

Dimensions

Carrel Electrade Limited
Proudly 100% New Zealand owned and operated.